Ardumoto - Motor Driver Shield
 Click on image to enlarge |
|
Ardumoto - Motor Driver Shield
sparkfun sku: DEV-09815
Description: The new version of this shield allows for either 3.3 or 5v logic, a separate and more robust VIN connection, and the PWM input has moved to pin 3.
This is a motor shield for Arduino that will control two DC motors. Based on the L298 H-bridge, the Ardumoto can drive up to 2 amps per channel. The board takes its power from the same Vin line as the Arduino board, includes blue and yellow LEDs to indicate active direction, and all driver lines are diode protected from back EMF.
Control for motor attached to OUT1/2 is connected to digital line 12 (direction A) and digital line 3 (PWM A).
Control for motor attached to OUT3/4 is connected to digital line 13 (direction B) and digital line 11 (PWM B).
Documents:
- Schematic
- Eagle Files
- L298 H Bridge data sheet
- Example Arduino sketch
- Assembly Guide
- Quickstart Guide
Replaces: DEV-09213
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
Click on image to enlarge
Click on image to enlarge
Click on image to enlarge
Click on image to enlarge
Click on image to enlarge
 Pololu High-Power Motor Driver 18v25 CS 00129 $58.95 |
 Pololu High-Power Motor Driver 18v15 00154 $38.95 |
 Pololu High-Power Motor Driver 36v9 00155 $43.95 |
 Pololu High-Power Motor Driver 24v12 00156 $41.95 |
 Pololu High-Power Motor Driver 18v25 00157 $48.95 |
 Pololu High-Power Motor Driver 24v20 00158 $51.95 |
 Pololu High-Power Motor Driver 36v15 00159 $53.95 |
 Arduino Uno 00181 $29.45 |
 Adafruit Motor/Stepper/Servo Shield kit for Arduino 00184 $19.45 |
 Arduino Stackable Header - 8 Pin 00188 $0.50 |
 Arduino Stackable Header - 6 Pin 00189 $0.50 |
